Evo Fixed TV Wall Mount | VM6

Choose the ULTI Evo VM6 when you want a fixed TV wall mount in Singapore with a clean, close-to-wall position. It is designed for compatible 40–80-inch flat or curved televisions. A fixed mount suits rooms where the main seats face the screen and you do not need to turn or tilt the TV after installation.

VM6 specifications at a glance

The screen-size range is only the first check. Before ordering, confirm the four mounting holes on the back of your television, the TV’s actual weight without its stand, the wall construction and the space required by rear-facing plugs.

Will this TV wall mount fit your television?

1. Measure the VESA pattern. Measure the horizontal and vertical distance between the mounting holes in millimetres. The VM6 dimension drawing covers 100–600mm across and 100–400mm vertically.
2. Check the television weight. Use the manufacturer’s specification for the exact TV model. If you cannot verify that the television is within the supported load for the mount and wall fixing method, ask ULTI before purchase.
3. Inspect the back of the TV. Raised housings, recessed mounting holes and rear-facing power or HDMI ports may need spacers or extra clearance.
4. Confirm the wall. The correct anchors and drilling method depend on the structural material behind the finish. Do not assume that every HDB, condominium or feature wall has the same construction.

Need help identifying the hole pattern? Use the ULTI VESA measurement guide before comparing brackets.

When a fixed TV mount is the better choice

A fixed bracket keeps the screen close to the wall and has fewer moving parts than an articulating arm. It is a practical choice when the TV can be centred on the main seating position, glare is already controlled and access behind the screen is not required often. Choose a full-motion model when the screen must turn toward different seats or extend away from the wall. The fixed, tilt and full-motion comparison explains the trade-offs.

Plan the wall, viewing height and cables together

The VM6 is 27mm deep, so cable planning matters. Check the depth of the power plug, HDMI connectors and any streaming device before fixing the wall plate. Side-facing ports are usually easier to reach after installation than rear-facing ports. Mark the intended screen centre from the seated viewing position, then check that the bracket rails, wall plate and cable route all fit the chosen location.

For concrete, masonry, timber framing, partition walls or feature panels, use hardware and a fixing method suitable for the actual substrate. Scan intended drill points for concealed electrical, plumbing and other services. If the structure is uncertain or the television is difficult to lift safely, use a qualified installer. Review ULTI’s Singapore TV wall mount installation guide and installation service scope before checkout.

Frequently asked questions

Will the VM6 fit a 55-inch or 65-inch TV?

Those sizes fall within the stated 40–80-inch range, but screen size alone does not confirm fit. The VESA pattern, television weight, back-panel shape, screws, spacers, wall and cable clearance must also be suitable.

Does the VM6 tilt or swivel?

No. It is a fixed mount intended for a straight-on viewing position and a low-profile result. Compare ULTI TV wall mounts in Singapore if your room needs angle adjustment.

Can it be used with a curved TV?

It can be used with a compatible curved television when the mounting pattern, weight, supplied or approved hardware and rear clearances are suitable for that exact model.

Can ULTI help me check compatibility?

Yes. Send the full TV model number, a photo of the rear mounting area and your wall type to ULTI on WhatsApp for a pre-purchase check.